
ENV - Set Environment
Network Auto Boot Enable [Y/N] = N?
YThe Network Auto Boot (NETboot) function is enabled.
NThe NETboot function is disabled. (Default)
Network Auto Boot at
YNETboot is attempted at
NNETboot is attempted at any reset. (Default)
Network Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User’s Manual for a listing of network controller modules currently supported by PPCBug. (Default = $00)
Network Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User’s Manual for a listing of network controller modules currently supported by PPCBug. (Default = $00)
Network Auto Boot Abort Delay = 5?
The time in seconds that the NETboot sequence will delay before starting the boot. The purpose for the delay is to allow you the option of stopping the boot by use of the BREAK key. The time value is from
Network Auto Boot Configuration Parameters Offset (NVRAM) = 00001000?
The address where the network interface configuration parameters are to be saved/retained in NVRAM; these parameters are the necessary parameters to perform an unattended network boot. A typical offset might be $1000, but this value is
6 |
http://www.mcg.mot.com/literature |