Multi-Tech Systems CDMA Wireless Modem Proxy Address +WDPXY, Wiota Connection Control +WIOTA

Chapter 23 - Sprint® Specific AT Commands

Proxy Address +WDPXY

Description: This command is used to read and write the proxy server address. The proxy server address is required for IOTA connections.

Note: Following a software load, the AT+WPRR command must be used to establish the default value.

Values:	<string>: 32 character maximum length string value in URL format.
	Default: 68.28.31.1
Syntax:	Command syntax: AT+WDPXY=<address>
	Command	Possible Responses
	AT+WDPXY?	68.28.31.2
	Note: Display the current proxy server address value.	OK
	AT+WDPXY=68.28.31.1	OK
	Note: Set the proxy server address value.	Note: New value set.
	AT+ WDPXY =””	+CERROR: BAD REQUEST
	Note: Set invalid address value.	Note: Error message displayed.

WIOTA Connection Control +WIOTA

Description: This command is to start an IOTA session.

Values:	1: Connect – Start IOTA session to get profile.
Syntax:	Command syntax: AT+WIOTA=<value>
	Command	Possible Responses
	AT+WIOTA=1	OK
	Note: Start IOTA session.	Note: Session started.

Sprint®. System Selection +WSSS

Description: This command is used to set the system selection and is persistent on reset. The values that are available with the +WSSS command are dependent upon the currently loaded PRL.

Values:	<pref> Preferred only systems:
	0: Home Only - Modem will operate on Sprint® PCS only.
	1: Automatic - Roaming allowed on affiliated systems.
	2: Analog only - Roaming rate applies.
Syntax:	Command syntax: +WSSS: <pref>
	Command	Possible Responses
	AT+WSSS=?	+WSSS: (0-3)
	Note: Show supported parameters	OK
	AT+WSSS?	+WSSS: 1
	Note: Get current setting	OK
	AT+WSSS=0	OK
	Note: Set home only	Note: Home only mode set.

Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 193