Multi-Tech Systems CDMA Wireless Modem manual Calling Line Identification Restriction +CLIR

Chapter 9 – Supplementary Service Commands

Calling Line Identification Restriction +CLIR

Description: This command allows control of the outgoing caller ID restriction supplementary service.

Values:	<mode>: sets the caller ID restriction for outgoing calls
	0: Outgoing Caller ID works normally, according to the subscription of the Caller ID
	service.
	1: Outgoing Caller ID is restricted. The called party will see ‘Restricted’ on their Caller ID
	display.
	Note that this command works by automatically pre-pending a *67 to the outgoing dialing
	string. Thus, this command will only work on CDMA networks that recognize a *67 to
	suppress outgoing caller ID. Also, the original dialing string cannot be longer than 29
	characters in length.
Syntax:	Command syntax: AT+CLIR=<mode>
	Command	Possible Responses
	AT+CLIR=1	OK
	Note: Restrict outgoing caller ID.	Note: Command valid
	AT+CLIR?	+CLIR :<mode>
	Note: Ask for current functionality	OK
		Note: <mode> as defined below

Calling Line Identification Presentation +CLIP

Description: This command allows control of the incoming caller ID presentation supplementary service. When presentation of the CLI (Calling Line Identification) is enabled (and the carrier allows), +CLIP response is returned after the RING unsolicited result code. By default, +CLIP is enabled.

Values:	<mode>: parameter enable or disables the caller ID unsolicited command
	0: Disable
	1: Enable
Syntax:	Command syntax: AT+CLIP=<mode>
	Command	Possible Responses
	AT+CLIP=1	OK
	Note: Enable CLIP	Note: CLIP is enabled
	AT+CLIP?	+CLIP:<mode>
	Note: Ask for current functionality	OK
		Note: <mode> defined as below
		RING
		Note: Incoming call
		+CLIP: “8585551212”,129
		Note: Incoming call with number presentation
	AT+CLIP=0	OK
	Note: Disable CLIP presentation	Note: Command valid

Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 69