Multi-Tech Systems CDMA Wireless Modem manual Reset +WRST, Set Standard Tone +WSST

Chapter 14 – Specific AT Commands

Reset +WRST

Description: This command is used to reset the modem after the specified <delay> time period. The <delay> value is entered in terms of hours and minutes.

Values:	<mode>
	0: timer reset is disabled
	1: timer reset is enabled
	<Delay> specify the time for reset (hrs:mins)
	“000:00”- “199:59”
	<RemainTime> time before next reset
	“000:00”- “199:59”
Syntax:	Command syntax: +WRST =<Mode>,<Delay>
	Response Syntax: +WRST: <Mode>,<Delay>,<RemainTime>
	Command	Possible Responses
	AT+WRST=?	ERROR
	AT+WRST=0	OK
	Note: Disable timer
	AT+WRST=1,”001:03”	OK
	Note: Enable timer and put delay at
	1 hour 3 minutes
	AT+WRST?	+WRST: 1,”001:03”,”001:01”
		OK
		Note: Timer activated to reset after 1 hour and 3 minutes. Actually 1
		hour and 1 minute remaining before next reset.

Set Standard Tone +WSST

Description:	This command is used to set/get the sound level of the Standard Tones.
Values:	<sound level>
	0: Max volume (default)
	4: Min volume (muted)
Syntax:	Command syntax: AT+WSST=<sound level>
	Command	Possible Responses
	AT+WSST=0	OK
	Note: Set volume to Max.
	AT+WSST=4	OK
	Note: Set the volume to Min (muted)	Note: Standard Tones are muted
	AT+WSST?	+WSST: 4
	Note: get current standard tones sound level	OK
		Note: Current level is 4
	AT+WSST=?	+WSST: (0-4)
	Note: Display valid parameter range.	OK

Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 105