Multi-Tech Systems MVP-2410, MVP-3010, MultiVOIPTM Parameters Field Name Values Description, 103

MultiVOIP User Guide				Technical Configuration
		E1 Parameter Definitions (cont’d)
	Field Name		Values	Description
	FXS Ground Start Supervision
	Parameters
	Tone Detection		Y/N	After a specified tone (chosen
	(Enable)			from the Available Tones list)
				coming from the PBX is
				stopped, the FXS interface will
				send the ‘connect’ signal to the
				calling party.
	Available		Busy Tone, Dial	List from which tones can be
	Tones (List)		Tone, Reorder Tone	chosen to signal call answer.
			Survivability Dial
			Tone, Unobtainable
			Tone
	Answer Tones		Busy Tone, Dial	Currently chosen call-answer
	(List)		Tone, Reorder Tone	supervision tone.
			Survivability Dial
			Tone, Unobtainable
			Tone
	ISDN		Parameters
	Field Name		Values	Description
	Enable		Y/N	If digital connection is ISDN-
	ISDN-PRI			PRI type, this box should be
				checked. When ISDN is
				enabled, the “CAS Protocols”
				field is grayed out (ISDN has its
				own signaling method).
	Terminal/		either	When “Terminal” is selected, it
	Network		“Terminal” or	indicates that the MultiVOIP
			“Network”	should emulate the subscriber
				(terminal) side of the digital
				connection. When “Network”
				is selected, it indicates that the
				MultiVOIP should emulate the
				central office (network) side of
				the digital connection.
				Setting used for MultiVOIP must be
				opposite to the setting used in the
				PBX. For example, if the PBX is set
				to “Terminal,” then the MultiVOIP
				must be set to “Network.”

103