National Instruments BridgeVIEW Wire Stretching, Selecting and Deleting Wires

Chapter 9 Creating VIs

Note When you place the Wiring tool over a node, G displays wire stubs that indicate

each input and output. The wire stub has a dot at its end if it is an input to the node.

Wire Stretching

You can move wired objects individually or in groups by dragging the

selected objects to a new location with the Positioning tool.

Selecting and Deleting Wires

You might wire nodes incorrectly. If you do, select the wire you want to

delete and then press <Delete>. A wire segment is a single horizontal or

vertical piece of wire. The point where three or four wire segments join is

called a junction. A wire branch contains all the wire segments from one

junction to another, from a terminal to the next junction, or from one

terminal to another if there are no junctions in between. You select a wire

segment by clicking on it with the Positioning tool. Double-clicking selects

a branch, and triple-clicking selects the entire wire.

Tip Strip

Wiring Tool