NEC 128/384 manual Irving 1201

VisuaLink 128/384 User Guide Chapter 8

8.2 Volume Control If the volume from the far-end is either too faint or too loud, you can adjust it with the VOLUME buttons on the hand held remote.

8.2.1 Increase the volume

①Press the VOLUME UP button.

Irving 12:01

VOLUME

UP

Volume 07 ) ) ) ) )

Local control: Camera 1

The volume bar appears on the monitor to show you the volume level. We recommend that you do not use the volume control on your monitor to adjust the volume because this may interfere with your ability to adjust the volume with the hand held remote. Also, if the volume of the monitor is too high or too low, the people at the far-end may hear echo. In general, leave the monitor volume level set to about middle position. If the far-end does hear echoes, turn the near-end monitor volume down until the echo disappears.

8.2.2 Decrease the volume

①Press the VOLUME DOWN button.

Irving 12:03

VOLUME

DOWN

Volume 03 ) ) ) ) )

Local control: Camera 1

NDA-24230 Issue 2.0 Page 8-3