VisuaLink 128/384 User Guide

Chapter 3

 

 

Chapter 3 Initial Setting and Operation Checking

After completing the external phase, start the initial setting of VisuaLink.

3.1 Preparation

Put the attached two batteries in the attached remote controller.

 

Turn the VisuaLink and all external equipment power in the ON position.

Position the TV monitor and the VisuaLink system so that they can be viewed.

3.2Turn Power ON or The VisuaLink can be turned ON or OFF by the POWER SWITCH on the front.

OFF

POWER

 

 

HEADSET

 

 

POWER

LINE

 

 

 

 

B1 B2-B6

 

 

 

 

Power Switch

Power LED

 

Turning on the power:

 

 

 

Press the POWER SWITCH on the front of the VisuaLink. While the unit is powering up, the green LED power lamp and Line B1 and B2-B6 light simultaneously. While the system is in an initialize state, a blue screen with the message Please wait for a while will be displayed on the monitor. When the VisuaLink has completed its initialization, the message will disappear and be replaced with a preview video image. In addition the B1 and B2-B6 LEDs will be extinguished.

Note 1: Unstable picture and sound may momentarily be output at the start of the initialization.

Note 2: If Line B1 B2-B6 LEDs do not extinguish after initialization (about 30 seconds), please turn power OFF and then back to the ON position.

Turning power OFF:

When the POWER SWITCH is pressed while the power is in the ON position, the power turns OFF. The power lamp extinguishes when the power is OFF.

NDA-24230 Issue 2.0

Page 3-1

Page 27
Image 27
NEC 128/384 manual Initial Setting and Operation Checking, Preparation, Power Switch Power LED, Turning power OFF