VisuaLink 128/384 User Guide | Chapter 4 |
|
|
Connection Procedure
①~ ➉ indicate the procedure numbers.
①Connect the Video Out of the VisuaLink to the TV Monitor
Using the attached video cable, plug one side into the connection marked VIDEO 1 IN on the TV Monitor. Plug the other end into the connection marked VIDEO OUT on the VisuaLink.
➁Connect audio from the VisuaLink to the TV Monitor.
Using the provided audio cable, plug one end into the AUDIO INPUT 1 of the TV Monitor. Plug the other end into the AUDIO OUTPUT of the VisuaLink.
Note: If a Voicepoint is used do not connect the audio output connection.
➂Connect the Voicepoint to the VisuaLink.
Using the attached RJ11 cable of the Voicepoint, plug the open end into the VisuaLink connection labeled TEL.
④Connect the NT1 device to the VisuaLink.
Using the provided data cable (RJ45 - RJ45), plug one end into the VisuaLink connection labeled ST/LINE. The other end of the cable, plugs into the NT1 device.
Note: If the NT1 device is located more than 300 feet (91 meters) away from the VisuaLink, set the NT1 to have a resistance of 100 Ω. This step
must be repeated three (3) times for a VisuaLink 384. NT1 does not need to be installed if network terminates in a PBX. In this case connect ST/LINE directly into wall jack.
➄Connect the Video Camera to the VisuaLink.
Using the provided video cable, plug one end into the connection marked VIDEO IN on the D30 camera. Plug the other end of the video cable into the VisuaLink connection labeled VIDEO IN 1.
⑥Connect the camera control to the VisuaLink.
With a 8 pin minidin to 8 pin minidin, plug one end into the D30 camera connection marked VISC IN. Plug the other end into the VisuaLink connection marked SERIAL 1.
➆Connect the camera power.
Plug the Camera AC Power to the AC Power Strip at the bottom of the cabinet.
➇Connect a PC to the VisuaLink for data sharing.
Using an 8 pin mini din to DB9 cable, plug the 8 pin end into the VisuaLink connection marked SERIAL 2/RMT. Plug the other end into the PC.
Page |
