NEC 128/384 manual ON/OFF Switch

VisuaLink 128/384 User Guide Chapter 4

STEP ACTION

23.Locate the network cable (RJ45-RJ45) and connect one end to the S/T LINE port of the VisuaLink 128 or VisuaLink 384. Connect the other end of the network cable into the network interface provided in the room wall.

Note 1: If the NT1 or network switch resides 300 feet (91 meters) or more away from the VisuaLink 128 or VisuaLink 384, it is recommended that the TERM switch is set to ON on the VL128.

Note 2: In the case a VL384 is being installed, the network interface card must be taken out of the system and the appropriate strap must be set.

Note 3: If the VL 384 is being installed, Step 23 must be repeated three (3) times.

		DRAWING
		RJ45 NT1 Cable
+			+						+
O
U
T			MIC1	MIC2	MIC3		TEL	S/T LINE
	+	+
I
N									+
VIDEO2	VIDEO1	AUDIO			Serial1	Serial2/RMT		DC IN 5V
			+
								-	+
		VisuaLink 128 Rear
			RJ45 NT1 Cable
+			+						+
O
U
T					TEL	S/T LINE 1	S/T LINE 2	S/T LINE 3
		MIC1	MIC2 MIC3

+ +

I
N
					+
VIDEO2	VIDEO1	AUDIO	Serial2/RMT	DC IN 5V
		Serial1
		+		-	+

VisuaLink 384 Rear

24.Locate the ON/OFF switch at the upper right outside of the cabinet. Press the switch to the ON position.

ON/OFF Switch

NDA-24230 Issue 2.0 Page 4-21