NEC 128/384 manual Mlp

Chapter 5 VisuaLink 128/384 User Guide

The setting screen is displayed. The current setting is displayed.

	▲ MLP Speed	:	< 4.0kb/s >
	LSD speed	:	< 1.2kb/s >
	Serial port setting
	Port 1	:	<	Camera >
	Port 2	:	<	Console	>
	User port speed	:	<	9.6kb/s	>
	T120 port speed	:	<	38.4kb/s	>
	Console speed	:	<	9.6kb/s	>
	Console parity	:	< 8 bit none >
	Press ENTER after choosing.
MLP:	Multi Layer data sets the speed for NEC far-end control.
	Note: MLP must be active in order to upgrade VL system
	on-line.
LSD:	Low Speed data sets the speed for far-end camera control.
Serial port setting:	Sets the type of control to be activated on the serial port.
User port speed:	Sets the data transmission rate for a point-to-point
	environment.
T120 port speed:	Sets the data transmission rate for a multipoint
	environment.
Console speed:	Sets the baud speed for a terminal which might be
	connected to the VisuaLink serial port.
Console parity:	Sets the parity and data length for a terminal which might
	be connected to the VisuaLink serial port.

Note 1: To select an item use the up and down portion of the CAMERA CONTROL button.

Note 2: To change a setting use the left and right portion of the CAMERA CONTROL button to toggle through the item.

Note 3: Appendix A is a table detailing MLP to LSD speed setting relationship.

➂Press ENTER button to define after changing a setting.

➃Press the MENU and CANCEL button three (3) times to proceed back to the video image.

Page 5-12 NDA-24230 Issue 2.0