Nortel Networks BCM50 To configure the date and time settings, To configure Dhcp server settings

138Chapter 14 Using Element Manager to set the basic parameters

To configure the date and time settings

1From the Configuration tab, click the System folder to expand it.

2Select Date and Time from the System folder. The Date and Time panel opens.

3Configure the Date and Time attributes (see Table 25).

Table 25 Date and Time attributes

Attribute	Description
Clock control	Set to NTP if the system uses a network server to determine the correct
	time and date.
	Set to Trunk if you want to receive time and date settings from PSTN (if
	available).
	Set to Manual if you want to be able to manually configure the time and
	date for your system.
NTP server	If clock control is set to NTP, then enter an address for the server.
Date and time	Use the dropdown calendar to select the correct date and time.
Year	If clock control is set to Trunk, then enter the current year.
Time zone	Select the time zone for this system.

To configure DHCP server settings

Note: This procedure is applicable only to a BCM50 main unit. If you have a BCM50a main unit or BCM50e main unit, the integrated router automatically disables the DHCP server.

Refer to the BCM50a Integrated Router Configuration Guide (N0027181) or the BCM50e Integrated Router Configuration Guide (N0027182) to configure DHCP server settings on the BCM50a or BCM50e main units.

1From the Configuration tab, click the Data Services folder to expand it.

2Select DHCP Server from the Data Services folder.

3Select the General Settings tab. It is normally selected by default.

N0027152 01