Nortel Networks manual To install the BCM50 unit on the wallmount bracket

86 Chapter 7 Installing the main unit

12If the BCM50 system has only one unit, skip to“To install the BCM50 unit on the wallmount bracket”.

If the BCM50 system has more than one unit, continue with the following steps.

13Prepare the additional wallmount bracket using the descriptions in step 5.

14Place the additional wallmount bracket on the backboard on the right side of the existing wallmount bracket. Use the alignment tabs to ensure the two wallmount brackets are properly aligned.

15Use three #8 x 2 cm (#8 x 0.75 in.) round-head wood screws to secure the wallmount bracket to the backboard (see Figure 32 on page 85).

16Open the cable management door.

17Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the cable trough.

18Repeat steps 13 to 17 for each additional unit.

If this is the last wallmount bracket for the BCM50 system, continue to “To install the BCM50 unit on the wallmount bracket”.

To install the BCM50 unit on the wallmount bracket

1Insert the power supply retention clip into the BCM50 unit.

2Slide the wallmount lock fully to the right (unlock position). See Figure 33.

Figure 33 Wallmount lock in unlock position

3Align the feet on the BCM50 unit with the four holes in the wallmount bracket (see Figure 34 on page 87).

N0027152 01