Nortel Networks BCM50 manual Insert screws

Chapter 24 Replacing an internal component 199

Figure 76 Hard disk and bracket screws

Insert screws

Insert screws

Caution: Use only the screws that you removed from the hard disk in the procedure “To remove the hard disk” on page 195. Using other screws may damage the hard disk.

4Set the hard disk and bracket in the main unit.

5Press down lightly on the top of the hard disk to ensure that the hard disk bracket is seated properly.

6Connect the power cable to the hard disk. Refer to Figure 73 on page 195 for the location of the cable.

Note: Do not force the cables.

The connectors on the power cable and the Serial ATA cable have a notch that prevents the cables from being inserted backwards. If the cables do not insert properly, check that the notch on the hard disk connector is aligned with the corresponding notch on the cable.

7Connect the Serial ATA cable to the hard disk. Refer to the figure Figure 73 on page 195 for the location of the cable.

8Ensure the fan cable is routed through the cutouts under the hard disk and bracket. Also make sure that any slack in the fan cable is secured in the clips on the hard disk bracket (see Figure 77 on page 200).

BCM50 Installation and Maintenance Guide