Nortel Networks BCM50 manual Wallmount bracket

Chapter 7 Installing the main unit 85

Figure 32 Wallmount bracket

1

2

2

1

1

2

Note: When using three screws, Nortel recommends installing the screws in the three holes labeled “1” or the three holes labeled “2”.

4Install one #8 x 2 cm (#8 x 0.75 in.) round-head wood screw in the backboard.

Do not tighten the screw head against the backboard. Leave approximately 0.5 cm (0.25 in.) of the screw exposed from the backboard.

5Prepare the wallmount bracket by removing the alignment tabs:

•If this is the only unit in the BCM50 system, remove the alignment tabs on the right side of the wallmount bracket.

•If this is the last unit on a BCM50 system with multiple units, remove the alignment tabs on the left side of the wallmount bracket.

If these options do not meet your requirements, other options that are more difficult to connect are available. For example, you can route the Amphenol connector cable to the left of the unit, or you can route the cable straight down the wall.

6Hang the wallmount bracket on the mounting screw.

7Use a level to make sure the wallmount bracket is level.

8Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the wallmount bracket (see Figure 32).

9Tighten the three wood screws against the wallmount bracket.

10Open the cable management door.

11Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the cable trough.

BCM50 Installation and Maintenance Guide