Nortel Networks BCM50 manual Unpacking the expansion unit

92Chapter 8 Installing an expansion unit

Refer to the following sections for information on installing an expansion unit:

•“Unpacking the expansion unit”

•“Verifying the media bay module switch settings”

•“Installing a media bay module in an expansion unit” on page 95

•“Installing the expansion unit” on page 95

Unpacking the expansion unit

Open the expansion unit box and remove all the components. Check that you have all the following components:

•one expansion unit

•one expansion unit power supply

•one power supply cable

•one expansion cable (shielded Ethernet cable)

•one power supply retention clip

•four rubber feet

•the BCM50 First Time Installation and Configuration Guide (N0027149)

Visually inspect the components for any damage that may have occurred during shipping. If you find any damage, contact your Nortel representative.

Warning: Make sure the power supply to the expansion unit is disconnected before inserting or removing an MBM.

N0027152 01