Nortel Networks BCM50 manual Removing the MBM, Inserting the MBM in the new expansion unit

186Chapter 23 Replacing an expansion unit

Removing the MBM

After you have removed the expansion unit, use the following procedure to remove the MBM from the expansion unit.

To remove the MBM

1Attach one end of a grounding strap to your wrist and the other end to a grounded metal surface.

2Grasp the right edge of the MBM ejector lever with your thumb, index and middle fingers. Pull outward to partially eject the MBM. Pull further on the lever to eject the MBM from the expansion unit. Refer to Figure 69.

Figure 69 Remove an MBM

Grasp the edge of the MBM ejector lever and pull outward

3Grasp the top and bottom edges of the MBM. Remove the MBM from the expansion unit. Place the MBM in a flat, clean, and static-free surface.

Warning: Protect the hardware components against damage from electrostatic discharge. Always wear a ground wrist strap before you handle components. Always place the components in a static-free container.

4Continue to the next step, “Installing the new expansion unit”.

Inserting the MBM in the new expansion unit

To insert the MBM in the new expansion unit, refer to “Installing a media bay module in an expansion unit” on page 95.

Proceed to the next step, “Installing the new expansion unit”.

N0027152 01