Chapter 10 Off-premise Message Notification 81
CallPilot Reference Guide
9Press OK or £ to accept the start time.
10 Enter the time when Off-premise Message Notification is to stop .
This is a four digit field. You must precede a single-digit hour and
minute with a zero.
11 Press AM or ⁄
or
PM or ¤.
12 Press OK or £ to accept the stop time.
13 Press YES or ⁄ to set up another destination number.
14 Press SETUP to set up another destination number.
15 Press PAGER or ‹ to select a pager number destination.
16 Enter the destination pager number and press OK or £.
17 Press OK or £ to accept the destination pager number represented
by <x>
or
press ADD or ¤ to add special characters and use your dialpad or
follow the voice prompts to add characters.
After you add special characters, press OK or £.
18 Press NEXT or £ to accept the default pager messag e represented
by <xxxx>. The default pager message that CallPilot sends is the
CallPilot extension. This is the sequence of digits that is sent after
the pager service is dialed, to notify you of who is paging you
or
press CHNG or ⁄ to change the pager message.
The combined limit is 30 characters for the pager phone number
and the pager message.
19 The display shows that the second destination is a pager.
Press NEXT or £ to continue.
20 Press NEXT or £ to continue
or
press SETUP to add another destination.
<start time>
RETRY OK
Stop hhmm:
RETRY OK
<stop time>
RETRY AM PM
<stop time>
RETRY OK
More dest?
YES NO
Notify2: none
SETUP NEXT
Destination:
PHONE E XT PAGER
Pager:
RETRY OK
<xxxx>
ADD OK
Show<xxxx>
CHNG NE XT
Notify2: pager
CHNG OT HR NEX T
Notify 3: none
SETUP NEXT