| Chapter 7 Command Line Interface (CLI) 79 |
|
|
Table 21 CNtrl directory CLI commands (Sheet 3 of 3) | |
|
|
CLI command | Description |
|
|
CoNlm <chan> | Transfers the channel to an online state. |
| Where: |
| chan is the channel number in the range of 1...15, 17...31. |
| If the system accepts the message, the channel becomes disabled. This |
| command sends a message to both protocol handlers. |
|
|
CoNlmGrp <start_chan> | Transfers a group of channels to an online state. |
<end_chan> |
|
| Where: |
| start_chan is the first channel in the group. |
| end_chan is the last channel in the group. |
| The values for start_chan and end_chan are 1...15, 17...31. |
| If the system accepts the messages, the channels become disabled. |
|
|
MC <link_num> | Sets the side that is used as clock source. |
| Where: |
| link_num is either 0 (link 0) or 1 (link 1). |
| If this command is entered without a parameter, the current clock master is |
| printed. |
|
|
COnfig directory
Table 22 includes the CLI commands for general card configuration. The commands are accessed from the COnfig directory.
Table 22 COnfig directory CLI commands (Sheet 1 of 2)
CLI command | Description |
|
|
LinePhy <phy_mode> | Sets the physical interface type of the external E1 line. |
| Where phy_mode can be: |
| 0 indicating 120 Ohm (RJ48 connector). |
| 1 indicating 75 Ohm (RX and TX, BNC connector), grounded shield. |
| 2 indicating 75 Ohm (TX BNC connectors), |
|
|
SaveCfg | Stores the current configuration on |
| All parameters are |
| stored configuration is used when the config DIP switches on the faceplate |
| are set to custom profile. Only one configuration (custom profile) is stored. |
| This command deletes the previous configuration contents. |
|
|
