88 Chapter 7 Command Line Interface (CLI)
Table 26 R2 directory CLI commands (Sheet 2 of 2)
CLI command | Description |
|
|
SeizeOption <link><flag> | Sets seize interworking with opposite link upon detecting seize from far end. |
| Where: |
| link is the number of the link, 0 or 1. |
| flag is either 0 (seize process is autonomic) or 1 (seize process is |
| dependant). |
| Autonomic - link responds to seize without waiting for opposite link ack. |
| Dependant - link waits for opposite link ack before sending its ack. |
|
|
SzAckOpt <link><flag> | Work with seize ack or not. |
| Where: |
| link is the number of the link, 0 or 1. |
| flag is either 0 (seize ack is not used) or 1 (seize ack is used). |
|
|
SearchMode <link><mode> | Sets MFC channel allocation mode. |
| Where: |
| link is the number of the link, 0 or 1 (applicable to link 0 only). |
| mode is either 0(round robin), 1 (linear ascending), or 2 (linear descending) |
| Round robin (default) - start search for next available channel after last |
| channel used. |
| linear ascending - search for next available channel from channel 1 up. |
| linear descending - search for next available channel from 30 down. |
| New defined mode is effective immediately after it is defined. It must be |
| saved, by using the SaveCfg command, to remain in effect after a restart. |
| The new mode is saved on the EEPROM, and is always in effect, regardless |
| of the Config DIP switch settings (mode is not part of the country code |
| configuration). |
|
|