5.8.3Opacity
The machine will properly reproduce documents which allow less than 40% of the scanner source light to pass through them.
5.8.4Shape
The feeding mechanism requires that input documents be rectangular in shape. The registration of triangular, circular and
5.8.5Document Condition
Slightly worn documents, such as those resulting from “normal office handling” will be accepted by the feeder without the use of a carrier. “Normal office handling” is defined to include staple holes, letter folds and minor corner folds, but excludes wrinkled copies.
5.9Document Damage
The document will not be marked, wrinkled or torn as a result of being sent through the feeder or scanner.
5.10Document Jam Detection
Transmission will stop and a line disconnection will occur when the end of the document is not detected within 356 mm after scanning begins (except if unlimited). A jam will also be declared if the document does not reach the scanning position within about 10 seconds after the start of a document feed, which will be fed automatically immediately after the document is set on the ADF.
Note:When a jam is detected during message transmission, the machine will stop, but its receiving capability will remain valid.
5.11Feeder Reliability
Jam occurrence and misfeeds in the automatic document feeder will be less than one in 500 operations for all documents and conditions specified in Section 5.7 “Input Document Characteristics” except oily documents and printed paper by itsself.
For oily documents and printed paper by itsself, it will be meet in Figure
40672201TX Rev.4 | 5 - 3 |