If the machine receives no CSI and no NSF from the distant station, the message on LCD display will be:

OKI-TOKYO

SENDING /144

SENDING /144

e)Transmission Starts

OKI-TOKYO is calling ID which is registered in One touch key.

Calling ID does not registered in One touch key.

After setting the document pages and storing the image data in the memory, the machine begins the handshaking with the distant station. If the 14400 bps training is successfully completed, then the machine will start transmitting the image data in digitally coded form. If the training fails due to the line condition, an automatic fallback to a lower rate will occur. The result will be indicated on

MCF REPORT.

f)Transmission Ends

When all of the document pages are transmitted successfully, the machine will automatically display the following message:

RESULT=OK

In either case mentioned above, the message on the LCD will return to time in about 5 seconds, indicating that the machine is again in standby state.

4.3.4Other Transmission Function (Fig. 4-3-1)

This machine is provided with other transmission functions listed below.

• Delayed TX

(Fig. 4-3-7)

• Confidential TX Programming

(Fig. 4-3-9)

• Relayed Broadcast initiate

(Fig. 4-3-10)

• Polling TX/RX Programming

(Fig. 4-3-11)

• TX preparation

(Fig. 4-4-16)

If a TX preparation request is made when memory full during reception or data transmission from memory, the machine sends the documents on the feeder at the completion of the current send or receive operation. In the operation of TX preparation the document is pre- feed.

This feature is available for the confidential message TX, relayed broadcast initiate, and memory transmission.

40672201TX Rev.4

4 - 21