In addition, LCD will display:

07/01/1998 14:57 TEL SELECT LOCATION

which prompts the operator to enter the telephone number of the station to which the document is to be transmitted.

b)Dialing

Manual Dialing (Local Keypad)

In this mode, the operator needs to tap all digits of the telephone number, 54456182, using the keypad on the Control Panel.

The operator hears a dial tone, and taps "5". The message on the LCD will be changed to:

5

The first digit entered (in the above example "5") will appear at the rightmost character position.

As the operator enters the digits serially, the entered digits will show up on the right of the previous digits, as:

54456182

When the operator completes dialing, the machine will complete dialing accordingly and the telephone number, 54456182, will remain on the LCD. The exchange will establish the connection with the called station through PSTN (Public Switched Telephone Network). Assuming that the call is answered, the operator will hear CED (Called Station Identification) tone from the distant station, since it is assumed that the distant station is set to the AUTOREC in standby. Hearing the CED, the operator presses the START key.

Pressing the START key causes the machine to switch the line connection to the facsimile facility, and proceeds to transmit the message. The message on the LCD is now changed to:

MANUAL TX START

The machine proceeds to message transmission which is identified by the "MANUAL SEND MODE" block shown at the rightmost in Figure 4-1-1.

40672201TX Rev.4

4 - 15