a)

Redial time (0 to 10 times: one time steps)

b)

Redial interval (1 to 6 minutes: one minute steps)

c)Dial tone detection (ON/OFF)

d)Busy tone detection (ON/OFF)

e)MF or DP (MF/DP)

f)DP rate (10/16/20 pps)

g)DP make ratio (33%/39%)

h)DP dial type (N/10-N/N+1)

i)MF duration (75/85/100 ms)

j)PBX Line (ON/OFF)

k)Flash/Earth/Normal (R/E/N)

l)Auto start (ON/OFF)

m)

Dial prefix

(0. 1. ... 9)

n)

IT2 detect (ON/OFF))

AUTO START:

If the AUTO START is turned ON, dial operation is

 

 

automatically started immediately.

 

 

If the AUTO START is turned OFF, dial operation is

 

 

started when the START key is pressed. If the START

 

 

key is not pressed within 60 sec., the machine is initial-

 

 

ized.

4.4.7.6Personal box programming

To allow operator to assigne a two functions to 8 personal-box.

(a)Confidential RX

(b)Bulletin Polling TX

Function:

Used with confidential RX and Bulletin Polling TX and Advanced T30 protocol.

 

Personal box setting for Bulletin poll using SEP frame and Confidential using

 

SUB frame when remote machine have a SEP/SUB capability.

Operation:

The programming operations are described in Fig. 4-3-1 and Fig. 4-3-22. The

 

box No. 0 is used for only grobal Bulletin Polling TX.

4.4.7.7 Memory password programming

Function:

Registering the password required (4-digit numerals) for outputting the data

 

received by Memory Only Reception mode or change from Memory Only

 

Reception mode.

 

When the four-digit numeric password is registered, the password input is

 

required upon outputting documents or change from Memory Only Reception

 

mode.

Operation:

The programming operations are described in Fig. 4-3-1 and Fig. 4-3-23.

40672201TX Rev.4

4 - 35