4.2.10START

Function: When pressed, will cause the machine to start up for whatever the operator has commanded to the machine in advance - for example, message transmission, manual message reception, technical programming, etc.

Display: When pressed, a message will appear on LCD display, which identifies the operation the machine will conduct.

4.2.11PLUS, PAUSE and SPACE

PLUS is No. 8, PAUSE is No. 9 and SPACE is No. 10

Function: One-Touch keys for PLUS, PAUSE and SPACE have dual functions, according to the timing at which the key is pressed.

When the operator is dial-selecting a distant location, those keys function as auto-dial One-Touch keys.

When the operator is programming assignment of telephone numbers to Auto Dial Codes, those keys represent symbols corresponding to "(plus)", “(space)” and “(pause command)”, respectively.

“Plus” is used to connect the next telephone number for chain dail.

“Pause” is used to place an interval of 3 seconds between two successive digits in dialing for the exchange discrimination purpose, wherever required.

“Space” may, or may not, be inserted between digits simply for better readabil- ity.

Display: During address selection, the full-digit telephone number assigned to No. 15 will appear on LCD display. If no telephone number is assigned, LCD display will show the following example prompt for 3 seconds.

NOT PROGRAMMED

During an auto dial code programming, a symbol corresponding to Pause Command, or Space will show up at the position where the cursor is located on LCD display, depending on the key pressed.

40672201TX Rev.4

4 - 8