5.Press the <Enter> key. The reader will beep twice to indicate the reader is now in the Setup Mode for group X.
6.Type the
7.Press the <Enter> key. The reader will beep twice to indicate the code is accepted by the reader as a valid code for Setup Group X.
8.Type the
9.Press the <Enter> key. The reader will beep twice to indicate the code is accepted by the reader as a valid code for that particular feature.
10.Repeat Steps 6 to 9 for any other features that you wish to change in the same Setup Group.
11.Save the changes and exit Setup Mode by typing XZ. (Of course, X must be the same group name entered in Step 4.)
12.Press the <Enter> key. The reader will sound four beeps to indicate
the new settings have been saved in the reader and the reader is back to the normal reading mode.
EXAMPLE:
To set the reader’s beep volume to LOW, enter following setup code in Notepad:
/E/D/FB<Enter>B1<Enter>1<Enter>BZ<Enter>
The setup routine is always the same, regardless of group:
1.Enter group setup mode.
2.Enter the feature selection code.
3.Change the setting for that feature.
4.Save the change and exit.
The reader’s response is always the same, regardless of group:
·Two slow beeps indicate the code has been accepted by the reader.
·Four slow beeps indicate the reader has saved the settings and has exited the setup mode successfully.
·Four quick beeps indicate the code entered is invalid and has been rejected by the reader.
Before proceeding to enter the next code, make sure the reader gives the correct number of beeps when <ENTER> is depressed.
4
