Track Two Send Accout Number Only
Track Two of a magnetically encoded credit card includes the account number information as well as other information. If this option is selected, all other- data contained on the track is suppressed before transmission.
SELECTION CODE: H3
Track 2 Send Account Number Only | A |
Track 2 Not Limited to Account Number | B |
Track Separator
One character from the Full ASCII Table: This option allows the user to select the character used to separate data decoded from each track when using mul- tiple track magnetic stripe readers.
H4<ENTER><SELECTED CHARACTER><ENTER>
Note: For no track separator, enter N. Default is <ENTER>.
Reviewing Configuration Settings
The reader’s current settings can be reviewed by following these steps:
1.Locate the group that contains the settings you want to review.
2.On an
3.Enter the setup mode for that group by typing /E/D/FX <Enter>. (X in this case is the single alpha character identified with the group located in Step 1.)
4.The reader will respond with two beeps after <ENTER> is depressed.
5.Review the settings for the group by typing XY<ENTER>. (X is the same single alpha character as typed in Step 3.)
6.After <ENTER> is depressed, the reader will display the current settings for the group onto the screen for user to review, followed by two beeps from the reader. *
7.Exit the setup mode after reviewing the settings by typing XZ <ENTER>. (X is the same single alpha character as typed in Step 3.)
8.The reader will respond with four beeps.
*Hyper Terminal must be configured correctly: Append Line Feed to Incoming Line End.
28
