EXAMPLE:
To review the reader’s current settings for the Code 39 bar code, first find the settings for Code 39 listed in the Industrial Bar Codes setup group. (The single alpha character group name is F.) Then in Notepad type: /E/D/FF<ENTER>FY<ENTER>
A sample response is shown below.
Remember to end the review by typing: FZ<ENTER> This will take the reader out of the setup mode and bring it back into its normal reading mode.
=======================================================
Industrial Bar Code Setting
Code 39 | Enabled; Full ASCII Off |
Min Length = 01; Max Length = 60; No Check Digit; | |
I 2 0f 5 | Enabled; Fixed Length Off |
Min Length = 01; Max Length = 60; No Check Digit | |
FEBRABAN | Enabled |
S 2 of 5 | Enabled; Fixed Length Off |
Min Length = 01; Max Length = 60; No Check Digit | |
Code 128 | Enabled |
Min Length = 01; Max Length = 60 | |
Codabar | Enabled; StopStart Not Send |
Min Length = 01; Max Length = 60; No Check Digit | |
MSI | Enabled; Check Digit Not Send |
Min Length = 01; Max Length = 60; Check Digit Double Modulo 10 | |
Telepen | Enabled, ASCII Mode |
Min Length = 01; Max Length = 60
=======================================================
29
