ID Tech | Omnitron Systems Technology RS-232 instruction

ID TECH

10721 Walker Street

Cypress, California 90630

(714)761-6368 www.id-tech.net

80028503-004

Rev. A R01/05

#428

Image 71

Omnitron Systems Technology RS-232 user manual ID Tech

Contents

Omnitm Page Agency Approved Limited WarrantyPage Table of Contents Page Description SectionIntroduction Host Connections Installation Magnetic Stripe Input ConfigurationConfiguration Setup Procedure Bar Code Input Example Serial Interface Parameters Group E Default Settings Parity Baud Rate Stop Bit General Selections Group B Scan Verification Beep VolumeCode/Track ID Enter one character for the new ID Code ID Definition Group Bar Code Terminator Character Bar Code Message Formatting Selections Group C Bar Code Postamble Bar Code Preamble Magnetic Stripe Terminator Character Magnetic Stripe Formatting Selections Group D Magnetic Stripe Postamble Magnetic Stripe Preamble Minimum and Maximum Length Options Bar Code SelectionsIndustrial Bar Codes Group F Full Ascii Code 39 SettingsEnable/Disable Code Send Start/Stop Characters Interleaved 2 of 5 SettingsEnable/Disable Interleaved 2 Check Digit Fixed Length Febraban Conversion Enable/Disable Industrial 2 Industrial 2 of 5 Settings Code 128 Setting Enable/Disable Codabar Codabar Settings Enable/Disable Telepen MSI/Plessey SettingsTelepen Setting Enable/Disable MSI/Plessey Retail Bar Codes Group G UPC SettingsEnable/Disable UPC-A UPC-E Expansion Enable/Disable UPC-ESend Number System Digit Send Check Digit Add Separator Space Read Two-Digit AddendumRead Five-Digit Addendum Addendum Required Send Induced Country Code Character EAN SettingsEnable/Disable EAN-13 Enable/Disable EAN-8 Read Five-Digit Addendum Do Not Read Five-Digit Addendum Send Start/Stop Sentinel Magnetic Stripe Selections Group HTrack Selection H4ENTERSELECTED Characterenter Reviewing Configuration SettingsTrack Two Send Accout Number Only Track Separator MSI Data Editing Data Fields Data Editing Formulas Code Idlengthmatchdivideaddsend Formula Sequence Track 1 %CABREADOE$JANE$R$310 S Jefferson ST? Using the Data Editing Functions Unmatched Input Send/Do Not Send Data Editing CommandsData Editing On/Off JDENTER0ENTER6ENTER1ENTER2ENTER Select Code IDsSet Length JFENTER0ENTER7ENTER Match StringCreate a Data Field JEENTER0ENTER8ENTERAENTERBENTER Centerdentereenter Jgenteraenterbentercenter Dentereenter Search for a Data StringAdd a Data Field Jkenteraentercenterbenter Time DelaySet the Sequence in which Data Fields are Sent Delete One Formula Omni Data Flow Reset Data Editing GroupReview Configurations Exit Data Editing Mode Examples Symbology Code JEENTER0ENTER7ENTER Send BD DLY 09 AD DLYJDENTER0ENTER7ENTER0 Enter 7ENTER MSR Track 1 data Operation Operating Procedure General Procedures Troubleshooting Serial Interface Problems Scanning Configurations Crlf Default SettingsAppendix a Industrial Bar Codes UPC-A UPC-E EAN-8 Retail BarcodesUPC-A, -E Magnetic Stripe Format Appendix B Magnetic Stripe Standard Data Formats Appendix C California Driver’s License Format Track LRE ID Aamva Driver’s License Format Track Full Ascii Table Appendix D Ascii RS-232 Port, Standard DB-9P Connector PIN-OUTSAppendix E USB/RS-232 Interface Installing the DriversAppendix F Page UE Anyway Troubleshooting Checking the Installation and Modifying the COM Port NumberTelling Whether the Installed Device is Type a or Type B Date Driver Updating the Driver Versal Serial BUS Controllers Removing the Driver ID Tech