Getting Started
Re-packing Information
To ensure maximum protection when transporting the printer, always:
SRemove any installed paper handling option.
SRemove the mains cable.
SRemove the ribbon cassette.
SReposition the transport lock.
SPack the printer in its original packing material and ship in its original package.
1.4Installing the Personality Module (PM)
The printer is only operational when an interface is installed, called a Personality Module (PM). The illustration below shows the standard PM with a serial and parallel interface.
Note: Never attempt to install or remove a PM while the printer is switched ON. To avoid damage due to electrostatic discharge, do not touch the pins or components of the PM.
SInsert the Personality Module (1) with the component side upwards until the connector fully engages. Hand tighten the two lock screws (2).
