Thumbnail operations (continued)
Shot mark
A shot mark can be added to a clip thumbnail to distinguish this clip from the others.
1 Turn the POWER/MODE switch to set to PB/ THUMBNAIL mode.
The thumbnail screen appears on the LCD monitor.
2 Push the Operation lever in the ◄ ► direction and position the pointer on the clip you wish to attach a shot mark to.
3 Press the USER button to which the shot mark function has been allocated.
•This adds a shot mark to the thumbnail of the clip at the pointer position.
•To delete a shot mark, position the pointer over the desired clip again and press the USER button to which the shot mark function has been allocated.
•“Using the USER buttons” (Page 39)
•A shot mark can be attached during recording.
•Adding shot marks after recording stops, attaches the shot mark to the most recently recorded clip.
··“Shot mark function” (Page 41)
•When adding a shot mark to (or deleting the shot mark from) a clip recorded across multiple P2 cards, do this with all these P2 cards inserted into P2 card slots.
Text memo
During recording or playback, you can add text memos to clips. Text memos can be used to play back clips at some point or break clips into chunks and copy the necessary portions.
Adding a text memo
Text memos can be added in one of the following ways.
•During recording/playback, press the USER button to which the text memo function has been allocated.
A text memo is attached at the position where the button was pressed. (Page 42)
•Pressing the USER button to which the text memo function has been allocated when the thumbnail screen is displayed adds a text memo at the start of the clip currently indicated by the pointer.
•“Using the USER buttons” (Page 39)
One clip can have up to 100 text and voice memos in combination. Note that camera- recorder is not capable of adding or showing voice memos.
82