Panasonic AJ-HD1800P (continued), Error messages

Error messages (continued)

zDisplay

Priority z Description

zVTR operation and remedial action E-01

Higher	LOW RF
	This is indicated when the embed level of the video
	head during playback, recording, and editing is about
	1/3 the normal level or less and is detected for 1
	second or more, or when the CTL level of the A/C
	head is about 1/6 of the normal level or less and is
	detected for 1 second or more.
	z The CTL level is not detected when DV/DVCAM is
	played back.
	z During recording and editing, only the embed level of
	simultaneous playback of video is detected.

VTR: Operation continues.

zExecute the cleaning operation for the video and A/C heads.

	E-02
	HIGH ERROR RATE
	This is displayed when the error rate increases and
	correction or interpolation is performed for either the
Lower	video or audio signals.
	VTR: Operation continues.

zClean the video heads.

Error messages

Display	z Description
	z VTR operation and remedial action
E-20	When condensation has been detected, the
DEW	AUTO OFF lamp lights, the message display
	blinks, and the VTR transfers to the EJECT mode.
	After the tape has been ejected, the drum
	continues to rotate in order to dry out the
	condensation.
	When the condensation has cleared, the AUTO
	OFF lamp goes off, the message display is cleared,
	and the VTR is ready for operation again.
	z When condensation is detected in the EJECT
	mode, the drum starts rotating as soon as it is
	detected.
	z When condensation is detected while a cassette
	is inserted, the drum stops rotating and starts
	rotating again after the tape has been ejected.
	VTR: EJECT
	z Wait with the power on.
E-29	If the cassette fails to move up even after 6
FRONT LOAD	seconds have elapsed since the VTR transferred
MOTOR	to the EJECT mode, the AUTO OFF lamp lights,
	and the message display blinks.
	<Note>
	If the cassette fails to move down even after 6
	seconds have elapsed since the cassette was
	inserted, the VTR transfers to the EJECT mode.
	VTR: Stops.
	z Set the POWER switch to OFF and then back to
	ON again.
E-31	If the unloading operation fails to be completed
LOADING	within 6 seconds, the AUTO OFF lamp lights, and
MOTOR	the message display blinks.
	<Note>
	If the loading operation fails to be completed
	within 6 seconds, the VTR transfers to the EJECT
	mode (unloading mode).
	VTR: Stops.
	z Set the POWER switch to OFF and then back to
	ON again.
E-35	When there is no response from the servo
SERVO	microcomputer for 1 or more seconds, the AUTO
CONTROL	OFF lamp lights, and the message display blinks.
ERROR	VTR: Stops.
	z Set the POWER switch to OFF and then back to
	ON again.
E-37	When the servo microcomputer does not follow
SERVO COMM	the instructions of the system control
ERROR	microcomputer even after 10 seconds have
	elapsed, the AUTO OFF lamp lights, and the
	message display blinks.
	VTR: Stops.
	z Set the POWER switch to OFF and then back to
	ON again.

129