Function menus (continued)
<HOME> (continued)
Registering TCG values1 Selecting the values
Press the | F3 | TC/CTL button to select TC. | |
Press the |
|
| button. The selected item (cue time or TC) |
| T | ||
is now highlighted.
Turn the ADJUST dial to select TC.
Again press the T button. A single digit is highlighted, and the mode for inputting numerical values is established.
2
3
<Notes>
zThe UBG value and cue time can be registered in the same way. The CTL value cannot be registered.
zTC or UB can be registered only when the internal time code generator has been selected.
Inputting numbers and letters
Press the | 0 | to |
| 9 |
| number keys to input numerical | |||||
values. |
|
|
|
|
|
|
|
|
|
| |
Use the | F |
| and |
| 7 |
| buttons to input A, B and C, and the | ||||
| and |
|
| buttons to input D, E and F. | |||||||
F | 8 |
| |||||||||
To move the input digit, turn the ADJUST dial.
To input a minus sign, press the F and TRIM– buttons when the
To input a “plus” symbol, press F and the TRIM+ button or press 0 when the digit to the far left is inverted. (The display goes blank.)
To clear all the digits to zero, press the F and 0 buttons.
<Notes>
zEvery time when the 7 button is pressed while
pressing the F button, the display changes in the following sequence: A > B > C > A > B and so
on.
The same applies when D, E and F are input using F and 8 .
zIf, when “REV” has been selected as the setup menu item No.144 (TC INPUT) setting, the F button is released while a letter is being input, the displayed character will be entered.
zLetters can be input only while a UBG value is being registered.
zThe input of a minus number is possible only while the cue time is being registered after “d12h” is selected as the setup menu No.002 (TAPE TIMER) setting and CTL is selected by the F3 TC/CTL button.
zIf “REV” has been selected as the setup menu item No.144 (TC INPUT) setting, the input starts from the highest order digit (the display appears from the far right). However, turning the ADJUST dial once will restore the NORMAL input mode.
Entering the input values
Press the ENT button. The value input is registered,
and the normal display is restored.
<Notes>
zTo cancel the registration, press the C button.
zIf the input value is outside the registration enable range, the INVALID alarm blinks, and the value cannot be registered until it has been corrected.
47