Function menus (continued)

<CARD>

Different kinds of settings and information can be stored or

retrieved from an SD memory card. When F2 (CARD) is pressed on the <MENU> screen while the F button is held down, the function menu shown below is displayed.

[MENU/ERROR LOG/MULTI CUE]

Memory selection cursor

Memory name

SHIFT F1 F2 F3 F4 F5 F6

Warning message 1

SYSTEM MENU/SETUP MENU/ 50PIN ASSIGN

 

File title (CARD)

File title (VTR)

File number

File number

(CARD)

(VTR)

 

SHIFT F1 F2 F3 F4 F5 F6

File status (CARD)

File status (VTR)

Warning message 2

MULTI CUE

SHIFT F1 F2 F3 F4 F5 F6

ERROR LOG

SHIFT F1 F2 F3 F4 F5 F6

<Notes>

zThe available capacity on an SD memory card is in the range from 8 MB to 2 GB.

zAn SD memory card must be formatted on the unit.

zAn SRAM card cannot be used.

zAn SDHC memory card cannot be used.

Warning message 1

A warning message about the SD memory card is displayed.

NO CARD

No memory card is inserted.

UNFORMATTED CARD

The SD memory card is not formatted.

Warning message 2

PROTECT!

SD memory card protection is turned [ON].

ACCESS!

This is displayed for the editing operation of F1 (FORMAT),

F2

(SAVE),

F4

(DELETE),

F5

(LOCK), and the file title

(CARD).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

File status (CARD)

File status (VTR)

 

Blank

No storage files are

_ _ _ _ _

 

 

 

present.

 

 

 

 

 

 

 

 

 

 

 

 

 

○

Storage files are present.

The target file is in the

 

 

 

(Unlocked status)

unlocked status.

 

 

 

 

 

 

 

 

 

●

Storage files are present.

The target file is in the

 

 

 

(Locked status)

locked status.

 

 

 

 

 

 

 

 

 

To insert an SD memory card

Insert an SD memory card (optional) into the SD memory card slot on the front left side; make sure the card’s notch is up.

SD memory card slot

<Note>

Insert the SD memory card after confirming that the direction of the SD memory card is correct. If the card does not slide smoothly into the slot but meets some resistance, the card may be upside down or the direction may be incorrect. Do not forcibly push the card into the slot, rather confirm the direction again, and then insert the card correctly.

To eject the SD memory card

After confirming that “ACCESS!” is not displayed on Warning Message 2, push the SD memory card into the unit further. When the SD memory card is ejected from the slot, remove the card.

Notes on the following points for using and storing the card.

zDo not use or store the card in a hot, humid place.

zDo not expose the card to water.

zPrevent electrification of the card.

zWhen “ACCESS!” is displayed on the Warning Message 2, the unit is accessing the SD memory card. Do not remove the SD memory card while it is being accessed.

71