Automatic Editing (deck-to-deck) (continued)

Checking the edit points

1 Press the IN (or OUT) button to check the edit point. The value of the registered edit point appears on the display.

2 While holding down the IN (or OUT) button, press the PREROLL button to check the picture at the edit point. The tape is cued up to the edit IN (or OUT) point, and a still picture of the point appears.

zIf “STOP” has been selected as the setup menu item No.307 (AFTER CUE-UP) setting, the VTR is set to the EE mode provided that EE has been selected as the <HOME> menu F1 (OUTPUT) setting.

3 By holding down the IN and OUT buttons at the same time, check the editing duration. The duration appears on the display.

How the duration is calculated

zWhen two edit points have been set

The duration between the two points is calculated.

zWhen only one edit point has been set

The duration between the data which has been set and the current address is calculated.

zWhen no edit points have been set

The duration of the previously edited section is calculated.

2 1, 3
Modifying edit points

1 Re-registering an edit point

Locate the new edit point by performing the jog or shuttle operation, and press the IN (or OUT) button and SET button at the same time to re-register the edit point.

2 Modifying an edit point in 1-frame increments (trimming function)

Press the TRIM button while holding down the IN (or OUT) button.

Each time the i button is pressed, the point is moved ahead by one frame.

Conversely, each time the j button is pressed, the point is moved back by one frame.

3 Resetting edit points

1Resetting both an edit IN point and OUT point Press F4 (TC CLR = RESET) on the <HOME> menu.

(This takes effect only in the CTL mode.)

2Resetting either an edit IN point or OUT point Press the C button among the number keys while holding down the IN (or OUT) button.

<Notes>

zAn edit OUT point can be reset even while editing is in progress.

zIn the eject mode, the IN and OUT points are automatically reset.

3￿

3￿

2

1

32