Rack mounting
The unit can be mounted into a
(The complete slide rail and bracket unit is not available from Panasonic.)
For further details, consult your dealer.
1 Attach the inner members of the slide rails. Refer to the figure below for the positions where they are screwed into place.
Positions where the right (R) inner member is screwed into place
2 Attach the outer member brackets to the rack. Check that the height is the same for the left and right brackets.
3 Remove the four screws at the front used to attach the left and right side panels.
4 Attach the
A B C D E F G H
Rack-mounting adapters
5 Remove the four rubber feet on the bottom panel of the VTR, and install the VTR in the rack.
After the VTR has been installed, check that it moves smoothly along the rails.
EIA standard rack
Inner member (18-inch rail)
A B C D E F G H
Inner member (22-inch rail)
<Notes>
•The length of the screws used is subject to a restriction.
•Use screws which are less than 2/5q (10 mm) long.
•Attach the inner member at the same symmetrical positions on the left (L) side as well. Fix the members in place using 3 screws on each side (total: 6 screws). When using the
•The letters shown in the figure are not actually marked on the side panels.
Fasten to rack with the fixing screws.
<CAUTIONS>
•Keep the temperature inside the rack to between 41xF and 104xF (5xC and 40xC).
•Bolt the rack securely to the floor so that it will not topple over when the VTR is pulled out.
116
