HOME

Function menus

<HOME>

Registering TCG values

1. Selecting the values

3. Entering the input values

Press the

F3

TC/CTL button to select TC.

Press the

 

button. The value input is

ENT

Press the

T

button. The selected item (cue time

registered, and the normal display is restored.

or TC) is now highlighted.

<Notes>

Turn the ADJUST dial to select TC.

•

To cancel the registration, press the C button.

Again press

the T button. A single digit is

•

If the input value is outside the registration

highlighted, and the mode for inputting numerical

 

enable range, the

 

alarm blinks, and

 

INVALID

values is established.

 

the value cannot be registered until it has been

<Notes>

 

 

 

corrected.

•The UBG value and cue time can be registered in the same way. The CTL value cannot be registered.

•TC or UB can be registered only when the internal time code generator has been selected.

2.Inputting numbers and letters

Press the 0 to 9 number keys to input numerical values.

Use the F + 7 buttons to input A, B and C, and the F + 8 buttons to input D, E and F.

To move the input digit, turn the ADJUST dial.

To input a minus sign, press the

F

and

 

TRIMj

]

buttons when the left-most digit is highlighted.

 

To input a plus sign, press the

F

and

 

 

]

 

TRIMi

buttons when the left-most digit is highlighted or press the 0 button.

(The display goes blank.)

To clear all the digits to zero, press the F and 0 buttons.

<Notes>

•When the 7 button is tapped while the F

button is held down, the display changes in the following sequence: A > B > C > A > B and

so on. The same applies when D, E and F are input using F and 8 .

•If, when “REV” has been selected as the setup menu item No.144 (TC INPUT) setting, the F button is released while a letter is being input, the displayed character will be entered.

•Letters can be input only while a UBG value is being registered.

•The input of a minus number is possible only while the cue time is being registered after “d12h” is selected as the setup menu No.002 (TAPE TIMER) setting and CTL is selected by the F3 TC/CTL button.

•If “REV” has been selected as the setup menu item No.144 (TC INPUT) setting, the input starts from the highest order digit (the display appears from the far right). However, turning the ADJUST dial once will restore the NORMAL input mode.

45