Panasonic HD1700pe manual Interface

Setup menus

<INTERFACE>

No./Item		Description of setting
200	For selecting whether to operate two or more
	VTRs in synchronization.
PARA RUN	0000	DIS:	The VTRs are not operated in
			synchronization.
	0001	ENA:	The VTRs are operated in
			synchronization.
	<Note>
	To operate the VTRs in synchronization, set all the
	VTRs to 1 (ENA). (Refer to pages 14 and 19.)
202	For setting what ID information is to be
	returned to the controller.
ID SEL	0000	OTHER
	0001	DVCPRO
	0002	ORIG
	<Notes>
	• For 0 (OTHER), the ID information of VTRs other than
	DVCPRO models is set.
	• Select 2 (ORIG) only when the VTR is connected to a
	Panasonic controller (such as the AJ-A900, an
	optional accessory).
	• Select 1 (DVCPRO) or 2 (ORIG) if the 23/24 Hz mode
	has been selected by system menu item No.25
	(SYSTEM FREQ).
204	For selecting whether the RS-232C connector
	is to function.
RS232C SEL	0000	OFF:	The RS-232C connector does
			not function.
	0001	ON:	The RS-232C connector functions.
205	For setting the RS-232C data transfer speed
	(baud rate).
BAUD RATE	0000	300
	0001	600
	0002	1200
	0003	2400
	0004	4800
	0005	9600
206	For setting the RS-232C data length.
	(Unit: bits)
DATA	0000	7
LENGTH	0001	8
207	For setting the number of RS-232C stop bits.
	(Unit: bits)
STOP BIT	0000	1
	0001	2
208	For setting whether the RS-232C parity bit is
	to be used and, if it is used, whether even or
PARITY	odd parity is to apply.
	0000	NON:
	The parity bit is not used.
	0001	ODD:
	The parity bit is used with an odd parity.
	0002	EVEN:
	The parity bit is used with an even parity.

The underlining (__) denotes the factory setting mode.

No./Item		Description of setting
209	For setting whether or not to return the ACK
	code when a command is received from RS-
RETURN ACK	232C.
	0000	OFF: The ACK code is not returned.
	0001	ON: The ACK code is returned.
212	For selecting the remote control connector
	for controlling the slave machine when this
MASTER	VTR is to be used as the master machine for
PORT	deck-to-deck operations.
	0001	IN/OUT: The IN/OUT connector is used.
	0001	OUT: The OUT connector is used.
	<Note>
	This setting takes effect only when the 9P button has
	been set to LOCAL (LED off).

87