Panasonic HD1700pe Commands relating to inquiries, CTL/TC Data, Request, Status, Stx Qid Etx

RS-232C interface

∫Commands relating to inquiries

<Notes>

•In terms of the return (completion) message, [ACK] is returned when data is received, and only the execution message which is subsequently returned is listed in the table.

•In the case of commands not listed in the table below, ER001 (invalid command) is returned after [ACK].

VTR	Send command				Return (completion)
operation						message
CTL/TC DATA	[STX] QCD [ETX]			45 [STX] CD data [ETX]
REQUEST
	This command is for inquiring about the counter
	value.
	data = f w gh mm ss ff
	f	=	F
	w	=	S
	gh =
	With CTL:
		g	=	SP(20h): for a plus display
				j(2Dh): for a minus display
		h	=	0 to 9:		hours
	With TC:
		gh		= 00 to 23: hours
		mm		= 00 to 59: minutes
		ss		= 00 to 59: seconds
	(525i system)
		ff	=	00 to 29: frames
	<Note>
	CTL or TC is returned, whichever corresponds to
	the front display mode.
STATUS	[STX] QOP [ETX]			45		[STX] 222 [ETX]
REQUEST
	This command is for inquiring about the VTR’s
	operation mode.
	222 = OEJ:		EJECT
	OFF:		FAST FORWARD
	OPL:		PLAY
	ORC:		REC
	ORW: REWIND
	OSP: STOP (including STANDBY ON)
	SRS:		(IN/OUT) PREROLL
	OBF:		STAND BY OFF
	OSF:		SHTL FORWARD
	OSR:		SHTL REVERSE
	OJG:		JOG FORWARD/REVERSE
	OSW:		VAR FORWARD/REVERSE
	EAE:		AUTO EDIT
	EON: EDIT ON (MANUAL EDIT)
	EPV:		PREVIEW
	ERV:		REVIEW
ID (VTR No.)	[STX] QID [ETX]			45		[STX] data [ETX]
REQUEST
	This command is for inquiring about the VTR
	used.
	data = AJ-HD1700

126