Panasonic HD1700pe manual Tape Protect

Setup menus

<TAPE PROTECT>

No./Item		Description of setting
400	For selecting the duration of the time taken
	after the VTR is left standing in the STOP or
STILL TIMER	search STILL mode (JOG, VAR or SHTL)
	before the tape protection mode is
	established.
	(Units: s = seconds, min = minutes)
	0000	0.5s
	0001	5s
	0002	10s
	0003	20s	<Note>
	0004	30s
	0005	40s	When a DV or DVCAM tape is
	0006	50s	used, the time is set to 10
	0007	1min	seconds even when a setting of
	0008	2min	2 (10s) or longer is selected.
401	For selecting the operation to be performed
	when the tape protection mode is established
SRC	after the VTR has been left standing in the
PROTECT	STILL status in a search mode (JOG, VAR or
	SHTL).
	0000	STEP:	STEP FWD
	0001	HALF:	Half-loading
	0002	T-REL:	Tension release
	<Notes>
	• When STEP FWD is selected, the VTR is
	automatically transferred to the standby OFF (half-
	loading) mode after it has been left standing in the
	STILL status for a total of 30 minutes (or 1 minute in
	the case of a DV or DVCAM tape).
	• When, after tension release has been selected and
	the VTR has been transferred to the tension release
	mode, the VTR has been left standing in this mode
	for a total of 2 hours, it is automatically transferred to
	the standby OFF (half-loading) mode. However, in
	the case of a DV or DVCAM tape, the transfer to the
	tension release mode is inhibited, and the VTR
	operates as if STEP FWD has been selected.
402	For selecting whether the drum is to operate
	in the standby OFF (half-loading) mode.
DRUM STDBY	0000	OFF: The drum stops rotating.
	0001	ON:	The drum continues to rotate.

<Precaution for STILL TIMER item setting>

The cumulative total standby time passed in the same location increases at such times when the same material is repeatedly used as is the case when programs are transmitted, for example.

The underlining (__) denotes the factory setting mode.

No./Item	Description of setting
403	For selecting the operation to be performed
	when the tape protection mode is established
STOP	after the VTR has been left standing in the
PROTECT	STOP mode.
	0000 STEP: STEP FWD
	0001 HALF: Half-loading
	0002 T-REL:Tension release
	<Notes>
	• When STEP FWD is selected, the VTR is
	automatically transferred to the standby OFF (half-
	loading) mode after it has been left standing in the
	STOP mode for a total of 30 minutes (or 1 minute in
	the case of a DV or DVCAM tape).
	• When, after tension release has been selected and
	the VTR has been transferred to the tension release
	mode, the VTR has been left standing in this mode
	for a total of 2 hours, it is automatically transferred to
	the standby OFF (half-loading) mode. However, in
	the case of a DV or DVCAM tape, the transfer to the
	tension release mode is inhibited, and the VTR
	operates as if STEP FWD has been selected.

90