Important Information

Installation and relocation

After moving the unit from cold areas to warmer areas, wait approximately 30 minutes before connecting the unit to allow the unit to adjust to the ambient temperature. If the unit is connected too soon after a sudden climate change, condensation may form inside the unit, causing malfunction.

Never install telephone wiring during a lightning storm.

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

Laser radiation

The printer of this unit utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

LED light

CLASS 1 LED PRODUCT

When using the unit, do not look directly at the CIS’s LED light. Direct eye exposure can cause eye damage.

CIS’s LED light properties

LED radiation output : Max. 1 mW

Wavelength : Green 520 nm typical

Emission duration : Continuous

Fuser unit

During or immediately after printing, the fuser unit gets hot. This is normal. Do not touch the fuser unit.

1

Fuser unit

Note:

LThe area near the recording paper exit (1) also gets warm. This is normal.

Toner cartridge

Be careful of the following when you handle the toner cartridge:

If you ingest any toner, drink several glasses of water to dilute your stomach contents, and seek immediate medical treatment.

If any toner comes into contact with your eyes, flush them thoroughly with water, and seek medical treatment.

For assistance, please visit http://www.panasonic.com/help

5

Page 5
Image 5
Panasonic KX-FL421 manual Installation and relocation, Laser radiation, CIS’s LED light properties, Fuser unit