Panasonic KX-TDE100 installation manual Connection

3.11Connection of Doorphones, Door Openers, External Sensors, and External Relays

2.Pass the wires through the hole in the base cover, and attach the base cover to a wall using 2 screws. Screw

To 8-pin terminal block

Note

Two kinds of screws are included with a KX-T30865. Please choose the appropriate kind for your wall type.

: when a doorphone plate has been fixed to the wall

: when you wish to install the doorphone directly onto the wall

3.Connect the wires to the screws located in the front cover.

To 8-pin terminal block

4.Re-attach the 2 halves and re-insert the screw.

Connection

Use 8-pin and 10-pin terminal blocks (included with the card) for connection.

1.While pressing down on the hole at the top of the terminal block using a screwdriver, insert the wire into the side hole as shown below. Repeat this procedure for other doorphones, door openers, external sensors, and external relays.

Refer to "3.7.2 DPH4 Card (KX-TDA0161)", "3.7.3 DPH2 Card (KX-TDA0162)",and "3.7.4 EIO4 Card (KX-TDA0164)"for pin assignments.

Doorphone

Door Opener

External Sensor/

External Relay Device

Installation Manual 213