Panasonic WV-CU650 Setup Procedures Firmware, Administrator Password Entry, Setting Modes

SETUP PROCEDURES (FIRMWARE)

■Administrator Password Entry

If you log into the system in the administrator mode, PS·Data communication setting, all reset, operator pass- word check. and database copy will become available.

To activate the administrator mode, you need to enter the administrator password.

Notes:

•The factory default of administrator password is “650”. However, for security, you should change the password setting. To change the setting, refer to p. 24.

•Take a note of your administrator password.

■Setting Modes

If you power on the system controller while pressing the fol- lowing buttons, the system will run in an associated setting mode.

Notes:

•You cannot change the system from the following modes (refer to the diagram) to the normal operation mode. To start up the normal operation mode, turn off the system controller, and then turn on the controller again.

•The administrator password entry is required for the fol- lowing modes.

Buttons pressed	Setting Mode	Description
while
the power-on
2, 4, and 6	All reset	The communication
		settings and
		PS·Data database
		can be restored to
		the factory default.*
MON (ESC) and 6	PS·Data	PS·Data communi-
	Communication	cation setting can
	setting	be performed.
MON (ESC) and 1	Administrator	The administrator
	password change	password can be
		changed.
MON (ESC) and 2	PS·Data database	The PS·Data data-
	copy	base can be copied
		from the source
		system controller
		(Controller No. 1) to
		a destination sys-
		tem controller.
MON (ESC) and 4	PS·Data password	The passwords of
	display	up to 16 operators
		can be displayed
		on the LCD.

*The panning, tilting, and zooming calibration settings are not restored.

19