●Group Address Setting for System Controller
Note: Remain the factory default. When you have mistaken- ly changed the setting, recover the factory default as follows.
1.Select “Cnt
2.Press the CAM (SET) button.
The LCD display will change from the display mode to the editing mode.
PS • Data Com. Setup
Cnt G—Adr.B
3.Select a desired parameter by rotating the JogDial or pressing the + or – button.
You can select the desired parameter from “A” to “Z”. The factory default is “A”.
PS • Data Com. Setup
Cnt G—Adr.A
4.Press the MON (ESC) button.
The selected parameter will be determined, and the LCD display will return to the display mode.
PS • Data Com. Setup
Cnt
●Group Address Setting for System Units
Note: Remain the factory default. When you have mistaken- ly changed the setting, recover the factory default as follows.
1.Select “Sys
2.Press the CAM (SET) button.
The LCD display will change from the display mode to the editing mode.
PS • Data Com. Setup
Sys
3.Select "A" by rotating the JogDial or pressing the + or – button.
PS • Data Com. Setup
Sys G—Adr.A
4.Press the CAM (SET) button.
The parameter will be determined, and the cursor will jump to the sub parameter.
PS • Data Com. Setup
Sys
5.Enter the unit number of system unit by rotating the JogDial or pressing the + or – button.
PS • Data Com. Setup
Sys
Note: 1 to 99 is available for the unit number. The facto- ry default is 01.
6.Press the CAM (SET) button.
The sub parameter will be determined, and "OK" will appear on the LCD.
PS • Data Com. Setup
Sys G—Adr.A 01 OK
After a second, the LCD display will return to the status in Step 5.
If you set the unit numbers of other system units, repeat Step 5.
Note: If the parameters cannot be determined, "NG" will appear on the LCD. In this case, check the unit number of system unit, and repeat Step 3 to 6.
7.Press the MON (ESC) button.
The LCD display will return to the status in Step 2.
8.Press the MON (ESC) button again.
The LCD display will return from the editing mode to the display mode.
23
