Paradyne 3000 manual Shared Diagnostic Control Panel Sdcp Installation

COMSPHERE 3000 Series Carrier

Preinstallation Inspection

Check the unit for physical damage. Ensure that the SDCP and ribbon cable are not damaged. If the SDCP or its cable shows signs of damage, report this immediately to your shipping representative and also to your AT&T Paradyne representative. Otherwise, install the ribbon cable as described in the Power Transformer Unit Installation section, then install the SDCP as described here.

Installation

The optional SDCP ribbon cable shown in Figure 3-12 is connected to the carrier backplane before the power transformer unit and optional fan module are installed. Refer to the Power Transformer Unit Installation section to connect the SDCP ribbon cable to the backplane, then continue with the following installation procedure.

Figure 3-12. Shared Diagnostic Control Panel (SDCP) Installation

3-18 December 1994 3000-A2-GA31-80