Paradyne 3000 manual Procedure

Installation

To install the carrier in a cabinet that has threaded screw holes:

.Procedure

1.If the carrier is to be installed in a 23-inch cabinet, you must reverse the mounting brackets. To do this, remove the screws that attach the mounting brackets to the sides of the carrier, then reverse the brackets and replace the screws.

2.Place the carrier against the front rails at the bottom of the cabinet, as shown in Figure 3-3, to determine where the two lower machine screws should be installed, then set the carrier aside. Use the larger screwdriver to install the two screws

loosely enough to allow the bracket keyholes to drop under the screw heads during installation.

3.Place the carrier against the front rails of the cabinet again, as shown in Figure 3-3, allowing the installed machine screws to pass through the keyholes. Lower the carrier into place, allowing the keyholes to slide under the screw heads.

This action positions the carrier correctly for installation of the two remaining machine screws and helps support its weight during installation of these screws.

4.Install the two remaining machine screws at the top corners of the carrier and tighten all four. Proceed to Step 5 of the following procedure.

Figure 3-3. Installation of First Carrier into Cabinet with Threaded Screw Holes

3000-A2-GA31-80 December 1994 3-7