Paradyne 3000 manual Customer Responsibilities, Installation Considerations

COMSPHERE 3000 Series Carrier

Customer Responsibilities

Preparing the installation site, including securing ac power with proper grounding, and verifying that you have the appropriate components for your site requirements are your responsibility. You can call your AT&T Paradyne representative, however, if you need assistance or have any questions.

When you order your COMSPHERE 3000 Series Carrier, certain components are supplied with your carrier; other components must be ordered separately.

Supplied with the carrier:

•3000 Series Carrier assembly

•Fuses

•Cable ties

•Signal ground/frame ground strap

You are responsible for ordering/supplying the following equipment:

•COMSPHERE 72-inch cabinet, or other non-AT&T Paradyne EIA standard 19- or 23-inch wide cabinet.

•Power transformer unit.

•Fan module(s), if needed.

•SDCP.

•Speaker panel (for use with the Models 3811 and 3911 modems), if needed.

•One digital or leased network interface cable for each of the eight DSUs or modems.

•TDM (and MCMP) and/or digital bridge interface cables, if needed.

•One or two Network Interface Modules (NIMs), if needed.

•One or two dial network interface cables, if needed.

•Connecting cables and cords. (For a complete list of the available cables and cords, see Appendix B of this manual.)

•Rear connector plates for optional pre-mounting. (Modular devices are packaged with rear connector plates, but you can also order rear connector plates separately.)

•Shared Diagnostic Unit (SDU), if needed.

•3151/3161 Auxiliary Backplanes, if needed.

•T1 CSUs, T1 DSU/CSUs, DSUs, DBM-Vs, DBM-Ss, DBM-Ds, and/or dial/lease modems, and options needed (DBMs, TDMs, MCMPs).

•Filler panels for empty slots.

•Applicable manuals

An equipment list is included at the end of this manual to assist you in ordering any additional components you may require.

Installation Considerations

Your installation site should be well-ventilated, clean, and free of environmental extremes. There should be 2 to 3 feet of clearance at the front and rear of the cabinet in which the carrier is to be installed to allow access for installation of the power transformer unit, (optional) fan module, and (optional) SDCP, as well as the network interface connectors, rear connector plates, and DTE cables.

HANDLING PRECAUTIONS

FOR

STATIC SENSITIVE DEVICES

AT&T Paradyne products are designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment. If you are not sure of the proper static control precautions, contact the nearest AT&T Paradyne Customer Support office.

2-2 December 1994 3000-A2-GA31-80