Depending upon your configuration, use one of the following interconnection schemes for a dial/dial backup interface (Figure 3-28): the 50-pin cable can be attached to a 66A-punchdown block. With this scheme, all dial circuits must be hard-wired to the block. Note that the connection type is defined by the NIM installed in that half of the carrier.
•The 50-pin cable can be used to connect a permissive DBM NIM to a 3600-F2-505 adapter cable. This arrangement is only used for DSU/DBM devices in the Permissive mode.
•The 50-pin cable can be used to connect a programmable DDD NIM to a 3600-F2-504 adapter cable. This requires that all devices in one half of the carrier be configured as programmable connections to the dial lines.
•The 50-pin cable can be used to connect a programmable DBM NIM to a 3600-F2-504 adapter cable. This arrangement is only used for DSU/DBM devices in the Programmable mode.
•The 50-pin cable can be plugged directly into an RJ21X (permissive) or RJ27X (programmable) dial network interface arrangement provided by the dial service provider. Only the first eight lines are wired in each 50-pin connector.
2-Wire Switched 56 kbps Network Interface
The 2-wire switched 56 kbps digital network interface is provided by an optional 2-wire Switched 56 Network Interface Module (NIM), which has a 50-pin connector, on the back of the carrier. Appendix A provides the pin assignments for this connector.
Depending upon your configuration, use one of the
following interconnection schemes available for a 2-wire switched 56 kbps backup interface (Figure 3-29):
•The 50-pin cable from a permissive NIM can be attached to a 66A-punchdown block. With this scheme, the circuits must be hard-wired to the block. Note that the connection type is defined by the NIM installed in that half of the carrier.
•The 50-pin cable from a permissive NIM can be connected to a 3600-F2-505 adapter cable.
NOTE
Do not insert a 2-wire switched 56 kbps plug into an RJ11C jack. This type of jack is intended for analog PSTN devices. Plugging into an RJ11C plug may cause equipment damage and harm to the telephone network.
4-Wire Switched 56 kbps Network Interface
The 4-wire switched 56 kbps digital network interface is provided by an optional 4-wire Switched 56 Network Interface Module (NIM), which has an SJA57-type connector, on the back of the carrier. Appendix A provides the pin assignments for this connector.
Depending upon your configuration, use one of the
following interconnection schemes available for a 4-wire switched 56 kbps backup interface (Figure 3-30):
•The 50-pin cable can be attached to a
66A-punchdown block. With this scheme, the circuits must be hard-wired to the block. Note that the connection type is defined by the NIM installed in that half of the carrier.
•The 50-pin cable can be plugged into a
3600-F2-503 adapter cable. This cable provides 8 keyed modular connectors using Pins 1, 2, 7, and 8. These connect the DSU to a standard DDS network interface and also provide the 4-wire switched
56 kbps digital service connection for the DSU/4-wire Switched 56 DBM.