SDCP Menus

Table 3-5

(3 of 5)

DTE Dialer Configuration Options

*Linefeed Char: 010 ASCI

Nxt 010 ASCI

Line Feed Character. Sets the character used to perform a line feed in Command mode for responses from the modem. The factory default is 010 (ASCII line feed character).

AT command equivalent is S-register S4=n.

*Result Codes: Enable

Nxt Enable Disable EnableInOrig

Result Codes. Result codes are informational messages (such as Connect and Ring) sent from the modem and displayed on the asynchronous DTE terminal. (For a list of result codes, refer to Appendix B.)

Enable ± Modem sends result codes to the DTE.

Disable ± Modem does not send result codes to the DTE.

EnableInOrig ± For UNIX applications, enable result codes only on the originating modem. This prevents the DTE on the answer side from interpreting result codes as login attempts.

For Async Dial, Enable is the factory default.

For UNIX Dial, EnableInOrig is the factory default.

AT command equivalent is Qn.

*ExtendResltCode: Enable

Nxt Enable Disable Add/EC Add/V42,MNP Use_DTE_Rate

Extended Result Codes. Informational messages such as VF data rate and Error Control are displayed with the result codes. (For a list of result codes, refer to Appendix B.)

Enable ± NO DIALTONE, BUSY, NO ANSWER, and CONNECT xxxx (xxxx = VF data rate) are displayed along with result codes listed in Appendix B.

Disable ± Only OK, CONNECT, RING, NO CARRIER, and ERROR result codes appear.

NOTE: NO DIALTONE is valid only if Dial Tone Detect configuration option is enabled. BUSY appears if Busy Detect configuration option is enabled.

Add/EC ± Places the EC suffix after the result code text if error control is used. For example, CONNECT 9600/EC.

Add/V.42, MNP ± Places either the /V.42 or /MNP suffix after the result code text if data compression is used. For example, CONNECT 9600/V42b.

Use DTE Rate ± Allows the DTE rate to be displayed in the Connect message instead of the line rate. This feature is required in some modem pooling applications.

The factory default is Enable.

AT command equivalent is Xn.

* This configuration option only appears if DTE Dialer Type is configured for AT.

3821-A2-GB20-40

January 1999

3-27

Page 53
Image 53
Paradyne 3821PLUS manual Linefeed Char 010 Asci Nxt ↑ 010 Asci, Result Codes Enable Nxt Enable Disable EnableInOrig