Paradyne 3821PLUS manual Line Dialer Configuration Options

COMSPHERE 3821Plus Modem

Line Dialer

The Line Dialer configuration options establish parameters used by the modem to answer or originate calls.

Table 3-6shows each Line Dialer configuration option as it appears on the LCD.

Table 3-6

(1 of 4)

Line Dialer Configuration Options

AutoAnswerRing#: 1

Nxt 1 Disable 2 4 6 8 10

Auto-Answer Ring Count. Determines the number of rings necessary before the answering modem answers an incoming call. For example, if this option is set for 2, then the answering modem answers after the second ring.

NOTE: Although SDCP selections are limited (1, 2, 4, 6, 8, or 10), values set by AT commands can display from 1 to 255 rings.

Disable ± If selected, the modem must be answered using either the SDCP's Answer command or via AT commands.

NOTE: The default and permitted settings of this option are country-dependent. See Appendix H.

AT command equivalent is S-register S0=n.

Dialer Type: Tone

Nxt Tone Pulse

Dialer Type. Selects either tone (DTMF) dialing or pulse (rotary) dialing mode.

The factory default is Tone.

NOTE: The default and permitted settings of this option are country-dependent. See Appendix H.

AT command equivalents are the Dial command modifiers T and P.

DialTone Detect: Enable

Nxt Enable Disable

Dial Tone Detect. Sets the modem for dial tone detection (enable) or blind dialing (disable).

Enable ± Modem disconnects the call if a dial tone is not detected within 10 seconds and displays No Dial Tone on both the LCD and asynchronous DTE terminal.

Disable ± Modem dials a call whether or not it detects a dial tone on the line. This is known as blind dialing. The period of time the modem waits before dialing is specified in the Blind Dial Pause configuration option.

The factory default is Enable.

AT command equivalent is Xn.

Blind Dial Paus: 2sec

Nxt 2sec 4sec 6sec 8sec 10sec 20sec

Blind Dial Pause. Determines how long the modem waits before dialing a telephone number when DialTone Detect is disabled.

NOTE: The Blind Dial Pause configuration option only appears when the Dial Tone Detect configuration option is disabled.

NOTE: The default and permitted settings of this option are country-dependent. See Appendix H.

AT command equivalent is S-register S6=n.

3-30 January 1999 3821-A2-GB20-40